Installation Considerations
For best results, Hansgrohe recommends that this unit be installed by a licensed, professional
plumber.
Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
This faucet requires a ½" NPT male nipple, extend-
ing ½" outside the surface of the nished wall.
Stud supports for the mounting ange must be
installed.
Extreme care should be taken to avoid damage to
hidden electrical or plumbing lines when drilling the
screw holes.
Do not use petroleum-based plumbers putty. If
desired, seal around the ange with silicone sealant.
•
•
•
•
•
•
Technical Information
Recommended water pressure 14.7 - 72.5 PSI
Hole size in mounting surface 1³⁄₁₆"
Max. wall thickness 1½"
Flow rate 2.2 gpm
This faucet is intended for cold water only.
Installation
Wrap the threads on the nipple with Teon tape.
Install the mounting ange. It should be centered over
the nipple.
Do not drill into electrical or
plumbing lines.
Comments to this Manuals